Meaning
The pressure loss observed within a mould cavity during the cooling phase represents the final stage of the injection cycle. Holding pressure decay occurs when the molten resin within the part shrinks as thermal energy dissipates into the tool walls, forcing the screw or piston to lose its ability to pack additional material into the frozen gate. A stable process maintains a consistent rate of reduction to ensure uniform part density throughout the production run.
Thermal Dynamics
Cooling profiles dictate the rate at which viscosity increases and thermal shrinkage proceeds. Polymers move from a high pressure state to an equilibrium with atmospheric forces while the gate remains open. Variations in wall thickness cause uneven zones where some sections reach solidification before others, preventing the effective transmission of pack pressure to remote locations.
This mismatch often leads to sink marks or internal voids if the duration of the packing phase remains insufficient.
Material Economics
Virgin resins possess predictable viscosity curves that allow for a controlled decline in internal cavity pressure over time. Regrind additives introduce inconsistent melt flow indexes which disrupt the laminar flow and alter the rate of pressure loss during the holding cycle. A molder must adjust the machine parameters to compensate for these rheological shifts to avoid high scrap rates or unstable part dimensions.
Standardized testing protocols establish the acceptable boundary for this pressure drop to guarantee that the final component matches the structural requirements defined in the design datasheet.
Tooling Efficiency
Cavity sensors provide the raw data required to quantify the velocity of pressure loss as the plastic sets. High quality moulds feature gate geometries designed to delay premature freezing so that enough volume resides in the tool to offset the volumetric contraction of the cooling polymer. Monitoring this variable helps identify worn check valves or leaking seals that would otherwise mask the true state of the cavity.
Accurate control over the tail end of the injection process defines the upper limit of precision for complex geometric parts.