Meaning
Chemical titration methods that utilize the quantitative reaction of water with iodine and sulfur dioxide provide the most accurate determination of water content in polymer materials. Testing for Karl Fischer moisture measures the trace amount of water present inside polymer pellets prior to processing. This method is the reference standard for hygroscopic resins like nylon or polycarbonate, where even trace water can cause severe hydrolytic degradation during moulding.
It provides a precise numeric value rather than a simple qualitative estimate.
Analytical Precision
Thermal weight-loss methods often fail to distinguish between water and other volatile compounds like residual solvents or monomers. Employing Karl Fischer moisture analysis solves this by reacting exclusively with water molecules, ensuring that the results reflect the true dryness of the resin. This precision is essential for high-performance resins where the moisture threshold is as low as zero point zero one percent.
An incorrect moisture reading can lead to a moulder using wet resin, which ruins the physical properties of the parts.
Moulding Correlation
Moisture trapped in a polymer during injection moulding causes hydrolysis, which reduces molecular weight and ruins the mechanical integrity of the parts. By monitoring Karl Fischer moisture levels before the material enters the hopper, engineers can ensure that the resin has been dried to its required specification. If the moisture is too high, the polymer will undergo chain scission in the melt, causing splay marks on the surface and brittleness in the finished parts.
Consistent verification helps avoid these expensive defects and ensures that the final parts meet their structural requirements.
Quality Standard
Most material datasheets specify the maximum moisture content allowed for safe melt processing of each resin grade. Quality control laboratories run Karl Fischer moisture tests to verify that the drying process has achieved the dry-air standards set by the resin manufacturer. This testing is particularly critical when using regrind materials, which can absorb moisture at different rates compared to virgin resins due to their irregular size and increased surface area.
If a laboratory detects moisture above the datasheet limit, the resin batch must be returned to the dryer to avoid producing defective parts. Documenting these values across a production run creates a reliable trace of part quality that protects the moulder against future liability claims or part failures in the field.