Meaning
Particulate contaminants consisting of degraded polymer or foreign matter present a visual defect in finished injection moulded components. These black specks typically originate from carbonized resin that has detached from the screw or barrel wall after prolonged exposure to high temperatures. They vary in size from microscopic dots to large visible flakes.
Contamination Source
Degradation often occurs in stagnant areas of the moulding machine where the melt flow is restricted or where dead spots allow the resin to bake. When these charred layers eventually break free, black specks enter the melt stream and are injected into the part cavity. This issue is particularly prevalent during transitions between high heat resins and lower temperature materials.
Regrind material containing dust or external dirt also introduces similar dark inclusions if the scrap handling process is not strictly controlled.
Removal Technique
Mechanical purging using high viscosity compounds or chemically active cleaning agents helps strip carbonized layers from the internal metal surfaces of the barrel. Efficient purging cycles reduce the downtime associated with black specks by forcing the accumulated debris out before production resumes. Moulders also inspect the screw tips and check valves for wear, as damaged components create more sites for resin to hang up and char.
Proper thermal profiling prevents the initial formation of these contaminants.
Economic Loss
Scrap rates increase when parts must meet strict aesthetic or medical standards that allow zero visible inclusions. A single occurrence of black specks can lead to the rejection of an entire production lot if the source of the contamination is not immediately identified. The cost of the lost resin and the energy spent on moulding unusable parts directly reduces the profitability of a run.