Meaning
Destructive chemical cleavage reactions that occur along already fragmented polymer backbones or within unstable radical intermediates continue the irreversible breakdown of macromolecular chain length under thermal and mechanical stress. Within injection moulding barrels and compounding extruders, secondary chain scission follows primary radical generation caused by excessive screw shear, localized overheating, or hydrolytic attack. The phenomenon permanently alters molecular structure throughout processing, terminating only when radical fragments combine into inert species, quench on stabilization additives, or exit the thermal process zone.
Degradation Pathway
Primary degradation events break weak bonds within the polymer backbone, generating free radical chain ends that undergo rapid rearrangement. Through beta-scission, hydrogen abstraction, and unzipping mechanisms, secondary chain scission systematically cleaves neighboring carbon-carbon bonds, converting high-molecular-weight chains into low-molecular-weight oligomers and volatile fragments. The cascade generates substantial quantities of short-chain molecules, radically altering the underlying molecular weight distribution.
Processors observing sudden melt flow rate increases during extrusion are witnessing this molecular fragmentation in real time. Antioxidants and hindered amine stabilizers arrest this progression by donating hydrogen atoms before secondary cleavages cascade through adjacent polymer segments.
Moulding Defects
Process shifts caused by progressive macromolecular fragmentation manifest directly as out-of-spec part dimensions and surface flaws. Low molecular weight fractions reduce melt viscosity, leading to parting line flash, tool fouling, and part ejector pin punch-through. As secondary chain scission liberates short oligomers and residual gases inside the barrel, these volatiles off-gas into the mould cavity, producing splay marks, burn spots, and cosmetic hazing across optical surfaces.
Regrind resin undergoes cumulative scission cycles, showing accelerated physical embrittlement compared to virgin feedstocks. Moulders run rigorous melt flow index tests on incoming regrind to detect severe molecular degradation before feeding resin into structural automotive or appliance tools.
Mechanical Loss
Cleaved polymer backbones lose their ability to form load-bearing molecular entanglements within the solidified plastic part. Components moulded from degraded polymers exhibit catastrophic drops in impact strength, environmental stress crack resistance, and ultimate elongation. A part that satisfies dimensional checks can fail brittlely under nominal impact loads if secondary chain scission was permitted to proceed unmitigated inside the plasticizing barrel.
Barrel temperature profiles and screw rotational speeds must remain tightly controlled to limit shear heating and prevent degradation cascades across production runs.