Meaning
Time-dependent permanent strain accumulates in a solid polymer subjected to a sustained mechanical load below its short-term yield strength. Viscoelastic molecular rearrangement causes creep deformation in molded plastic assemblies under long-term structural loading. This phenomenon applies to all semi-crystalline and amorphous thermoplastics exposed to constant stress, but ceases to describe immediate elastic response or high-rate impact loads.
Viscoelastic Mechanism
Polymer chains gradually uncoil and slip past one another when exposed to continuous physical forces over extended durations. Increasing ambient temperature accelerates chain mobility, causing creep deformation to occur at significantly lower load thresholds. Amorphous resins like polycarbonate resist initial movement through entanglement, while crystalline domains in polyolefins yield gradually under continuous stress.
Regrind Sensitivity
Injected parts molded from reprocessed material exhibit elevated deformation rates under continuous load compared to components produced entirely from prime virgin resin. Thermal degradation during prior molding cycles breaks polymer backbones, reducing overall molecular weight and lowering resistance to long-term strain. Creep deformation progresses faster in regrind components because shorter chain lengths slip more readily under sustained mechanical forces.
Tooling designers compensate by increasing wall thickness or adding structural reinforcing ribs to load-bearing parts.
Retention Yield
Data sheets report tensile modulus measured over seconds, failing to capture time-dependent strain occurring over months or years. Long-term dimensional stability requires engineering design based on creep modulus rather than short-term tensile properties. Part design guidelines establish maximum working loads to prevent permanent creep deformation during product service life.