Meaning
Spatial registration between the fixed and moving halves of a tool. Proper cavity alignment ensures that the parting line shutoffs meet without offset. This property governs the flash levels and dimensional symmetry of the finished part.
It ceases to apply once the tool is fully open and the parts are ejected.
Positional Integrity
Precise positioning prevents the formation of flash at the parting line during the high pressure phase of the injection cycle. If the two halves shift slightly, the plastic melt enters the gap and creates thin fins of material. This defect increases the secondary labor costs needed for manual trimming.
Registration Mechanism
Leader pins and bushings provide initial guidance during the closing stroke. Hardened steel interlocks take over as the mould finishes its travel to ensure the final position is within microns. These components act as the primary defense against side loads generated by non symmetrical parts.
Regular inspection for scoring on these surfaces prevents permanent damage to the cavity steel.
Operational Impact
Wear in the guidance components degrades the precision of the shutoff surfaces over time. If the plates do not meet exactly, the resulting part will have a visible witness mark or dimensional variation across the split. Regular lubrication of the pins helps maintain the accuracy of the system for several million cycles.
Lubricant selection must avoid contaminating the resin stream.