Meaning
Non-crystalline polymer macromolecular segments whose molecular mobility is constrained by physical anchoring to adjacent crystalline lamellae constitute a distinct structural phase within semi-crystalline plastics. The rigid amorphous fraction resides in the interphase boundary between ordered crystal lamellae and the fully mobile amorphous bulk, exhibiting immobility at the conventional glass transition temperature without possessing periodic crystalline order. Because its mobility is restricted by crystalline attachments, this fraction does not contribute to the heat capacity step change measured at the glass transition point.
The concept applies exclusively to semi-crystalline polymers, remaining completely absent from fully amorphous thermoplastics or cross-linked thermosetting resins that lack crystalline morphology.
Morphological Structure
Semi-crystalline polymers segregate into three distinct structural states: a crystalline phase, a mobile amorphous phase, and this intermediate rigid region. Crystalline lamellae fold polymer chains into dense, ordered arrays, forcing emerging chain segments to transition through a geometrically cramped interphase zone. Chains in this transitional boundary lack the geometric alignment required for crystalline unit cells but remain tethered to the crystal faces, severely constraining their torsional mobility.
The rigid amorphous fraction devitrifies only at elevated temperatures well above the standard glass transition, occasionally remaining immobilized until the onset of melting.
Thermal Measurement
Temperature-modulated differential scanning calorimetry quantifies the distribution of these three morphologic states by measuring reversing heat capacity across thermal transitions. The mobile amorphous content is calculated directly from the magnitude of the heat capacity step at the glass transition, whereas wide-angle X-ray scattering or fusion enthalpy determines the crystalline fraction. Subtracting the crystalline and mobile amorphous percentages from the total mass leaves the precise content of the rigid amorphous fraction: Fraction = 1 – Mobile Amorphous – Crystalline.
This immobilized amorphous content shifts thermal relaxation spectra and accounts for missing heat capacity increments observed during dynamic thermal analysis.
Mechanical Influence
Part stiffness, impact resistance, and gas barrier properties depend directly on the proportion of rigid amorphous material formed during processing. Fast cooling rates in injection moulding quench mobile amorphous chains without developing thick interphase zones, yielding tough parts with lower yield strength and reduced dimensional stability. Slower cooling or in-mould annealing promotes crystalline growth and expands the rigid amorphous fraction, raising the elastic modulus and improving creep resistance under mechanical loads.
Permeation rates for oxygen and moisture decrease as this rigid interphase expands, because the lack of chain mobility hampers the micro-Brownian fluctuations required for small molecules to diffuse through the polymer bulk.