Meaning
Determination of the physical density of solid polymer samples is achieved by measuring the apparent change in weight when the material is submerged in a liquid of known density. This technique, called immersion density, provides a highly accurate way to monitor crystallinity and voids in molded parts. It represents a critical quality control metric for both virgin and regrind resins, as density correlates directly with physical properties like stiffness and yield strength.
The methodology is limited to samples that are completely insoluble in the testing liquid and do not absorb it during the test.
Measurement Method
Testing begins by weighing the molded specimen in air on a high-precision balance before suspending it in a liquid bath. In this environment, immersion density is calculated using Archimedes’ principle of buoyancy. Water is the most common immersion liquid, though silicone oil or ethanol are used for specific polymers.
The liquid must contain a surfactant to prevent air bubbles from clinging to the part.
Resin Specification
Molded parts produced from semi-crystalline resins like polypropylene or polyethylene rely on density values to confirm the degree of crystallinity achieved during cooling. The datasheet value of immersion density acts as the target, whereas the actual molded value depends on the cooling rate in the mold. Fast cooling reduces density by restricting crystal growth.
Moulders use this measurement to adjust cycle times and cooling line layouts.
Defect Detection
Sinks and internal voids are identified quickly using this mass-to-volume ratio. Discrepancies in immersion density reveal issues that a micrometer cannot measure. A part with internal microvoids has a lower density than a solid part.
This causes mechanical failure under load.