Meaning
Proportionality factors in thermal boundary layer mechanics quantify the rate of heat transport between a solid boundary and a moving fluid per unit surface area and temperature differential. Within polymer injection tooling, the convective heat transfer coefficient defines the heat flux passing from the mould metal into liquid coolant flowing through cooling passages. The parameter governs mold surface temperature stabilization between plastic injection pulses, stopping when conduction through the tool steel or polymer skin dominates total thermal resistance.
Boundary Condition
Thermal boundaries within drilled cooling circuits depend directly on coolant composition and linear flow velocity. While moulders often adjust supply temperature at the temperature control unit, the convective heat transfer coefficient determines whether that thermal drop reaches the steel. Ethylene glycol mixtures reduce this value relative to pure water because glycol increases kinematic viscosity while reducing thermal conductivity.
Virgin resin processing datasheets present ideal cooling rates, yet coolant degradation or microbial scaling within internal channels throttles heat flux through the pipe boundary layer.
Flow Threshold
Fluid motion inside internal cooling channels must achieve Reynolds numbers above four thousand to produce fully turbulent flow. Below this transition zone, laminar layers act as an insulating blanket against the channel wall, dropping the convective heat transfer coefficient to fractions of its required value. Achieving turbulent conditions requires higher pump delivery pressures across the manifold.
Tool designers size bore diameters specifically to sustain fluid velocity without exceeding chiller pressure limitations.
Production Consequence
Mould cavities operating with depressed film transfer coefficients suffer prolonged dwell requirements and uneven shrinkage. When the convective heat transfer coefficient falls across specific circuits, parts develop differential cooling stresses that generate warpage and sink marks across thick ribs. Cycle duration extends because processors must hold parts under clamp pressure until ejectable stiffness develops throughout the wall thickness.
Regrind plastics with variable melt flow rates exacerbate these issues by shifting thermal load distributions across the impression. Tool steel choices such as beryllium copper provide high bulk conduction, yet heat removal remains bottlenecked if convective heat transfer coefficient values at the water interface remain sluggish.