Meaning
Optical measurement errors occur when light reflections off steep tool wall surfaces enter non-contact surface profiling sensors. In polymer tool inspection, cavity sidewall scattering describes the redirection of incident sensor illumination by steep metallic tooling walls into adjacent inspection zones. This stray light skews optical height calculations on textured mould inserts.
High reflection intensity from tool steel causes false surface height readings along deep vertical features.
Optical Distortion
Light beams striking polished tool steel at oblique angles reflect secondary beams across adjacent cavity features. Surface height measurements on micro-textured polypropylene plaques lose fidelity because stray illumination creates spurious signal peaks. Unintended reflection artifacts alter peak-to-valley height data during tool verification.
Standard optical sensors misinterpret these secondary reflections as genuine surface elevations.
Moulding Origin
Machining marks on deep cavity sidewalls alter local reflection angles during non-contact inspection. Ejection pin locations and steep draft angles increase tool wall reflection when surface roughness Ra values fall below targeted limits. Injection pressures exceeding ninety megapascals push polymer melt into microscopic tool grooves, reproducing these wall defects on final molded parts.
Processing parameters like melt temperature alter resin shrink rates, shifting the physical location of replicated sidewall artifacts. Moulders holding tight dimensional tolerances must distinguish physical polymer geometry from optical reflections generated during cavity inspection.
Metrology Boundary
Non-contact optical profilometers encounter physical measurement limits when draft angles drop below five degrees. Calculated roughness values diverge from physical stylus measurements on steep vertical walls. Cavity sidewall scattering invalidates optical surface data near deep cavity corners.