Meaning
Injection phase control governs the delivery of supplementary polymer melt into a mould after initial volumetric filling to compensate for volumetric shrinkage during cooling. Effective cavity packing maintains hydraulic or electric pressure through the machine screw tip, driving additional molecules through the runner system and gate before solid skin solidification seals the orifice. The protocol governs final part weight, linear shrinkage, sink mark suppression, and structural void elimination across thick-walled geometry.
Its application boundary terminates at the moment of gate freeze, after which subsequent pressure applied by the injection unit cannot affect the mass or density of the material locked within the impression.
Densification Phase
Molten thermoplastics experience significant volumetric contraction as thermal energy transfers into the regulated steel tooling. Unchecked cooling causes semi-crystalline polymers like polypropylene or polyamide to shrink up to twenty percent by volume as molecular chains align into crystalline lamellae, while amorphous resins contract roughly five to seven percent. Controlled cavity packing forces dense polymer into these thermal voids under sustained packing pressures, which typically sit between fifty and eighty percent of the peak filling pressure.
Screw forward position advances incrementally during this duration, forming a distinct cushion of reserve melt that isolates the screw face from bottoming out against the barrel end cap. Without an adequate melt cushion, the transfer of set packing pressure collapses immediately.
Process Drift
Inconsistent barrel thermal regulation, non-uniform regrind blending, or ambient shop floor swings alter melt viscosity and disrupt cavity packing efficiency. Higher fractions of recycled polymer introduce molecular weight variations, lowering melt strength and shifting gate freeze timing across automated cycles. Premature gate solidification leaves the internal core underpacked, producing deep exterior depressions, internal vacuum cavities, or severe warping caused by unbalanced volumetric shrinkage gradients.
Excessive holding pressures or prolonged times conversely cause gate area overpacking, resulting in high frozen-in molecular orientation, localized residual stress, and ejection cracking. Part mass verification on analytical balances isolates these packing anomalies long before dimensional deviations show up on coordinate measuring equipment.
Tooling Consideration
Steel gate dimensions, runner geometries, and water line distances establish the strict processing window available for cavity packing. Submarine, pin, or edge gate land lengths dictate how quickly heat conducts away from the resin into the chilled mould wall. Narrow gate orifices freeze prematurely under rapid thermal decay, preventing the machine screw from densifying remote thick wall sections regardless of hydraulic pressure increases.
Positioning water cooling circuits close to primary gate locations accelerates solidification and shortens cycle times at the expense of pack time. Runner systems must therefore maintain adequate cross-sectional thickness to preserve an open hydraulic pathway until every cavity impression achieves target pack mass.