Meaning
Hydraulic shock waves produced by rapid fluid velocity changes generate transient pressure surges in closed piping networks. In injection moulding plant cooling circuits, water hammer occurs when fast-acting solenoid valves snap shut during rapid mould cooling cycles. Kinetic energy of flowing water converts instantly into extreme pressure spikes that travel through cooling channels and flexible hoses.
This hydraulic surge phenomenon ceases when fluid velocity changes occur gradually or when surge dampeners absorb the shock energy.
Pipe Integrity
High pressure surges generated by valve closure exceed standard operating pressures of mould temperature control units. Repeated water hammer causes fatigue failure in copper cooling lines and leaks inside conformal cooling channels. Plant engineers install slow-closing valves to protect mould cooling infrastructure from sudden pressure spikes.
Cooling Circuit
Datasheet pressure ratings for cooling hoses reflect steady static fluid pressure rather than dynamic shock loads. Under water hammer conditions, localized shock waves reach peak pressures three to five times higher than pump supply pressure. Variotherm cooling systems using alternating steam and cold water are particularly vulnerable to violent pressure surges when valves switch rapidly.
Equipment damage leads to unplanned machine downtime and potential water contamination inside hot mould cavities.
Surge Prevention
Installing hydraulic accumulators or air chambers absorbs energy spikes and stabilizes fluid pressure. Controlled valve closing speeds prevent shock wave formation and maintain consistent cooling water flow.