Meaning
Dimensional variation between the thickest and thinnest cross-sections of a moulded component defines the wall thickness ratio. Calculation involves dividing the maximum measured wall thickness by the minimum wall thickness within the same part geometry to identify the deviation from a uniform profile. This quantitative relationship governs the consistency of material flow during the injection phase.
Proper control over this metric prevents the internal stresses that generate warped geometries or sink marks in finished plastics.
Flow Balance
Consistent cooling relies on the ability of a part to lose heat across all faces at a uniform rate. Variations in the wall thickness ratio force the molten resin to navigate segments of disparate thermal mass. Thick sections require extended hold times to reach full crystallization while thin sections solidify rapidly under pressure.
Disparate cooling leads to differential shrinkage where the material pulls away from the tool walls unevenly.
Moulding Economics
Virgin resin costs rise when part designs mandate thick walls to accommodate structural requirements. Processors attempt to compensate for non-uniform sections by extending cycle times to prevent voids, but this inefficiency increases the cost per unit produced. Regrind material introduces further complexity because it exhibits different flow characteristics than virgin pellets, making extreme ratios difficult to fill without high pressure settings.
High variance necessitates complex tool modifications to ensure the cavity fills before the plastic freezes.
Geometry Constraints
Designing around a fixed ratio ensures the production of repeatable parts. Minimum and maximum thresholds emerge from the rheological properties of the specific polymer grade used for the batch. Engineers aim for a value near one to eliminate turbulence at the transition points between thin and thick zones.
Rigid control of this variable remains the primary technical defense against part failure under mechanical load.