Meaning
Dimensional adjustment made to the size of a mould cavity to compensate for the expected shrinkage of the polymer during cooling. This tool steel offset ensures that the final part reaches the correct engineering dimensions after it has fully contracted. The amount of offset depends on the specific resin grade and the geometry of the part.
Calculation Method
Engineers multiply the nominal dimension of the part by the shrinkage rate provided on the material datasheet. For example, a resin with a one percent shrinkage requires the tool to be one percent larger than the finished part. This calculation is complicated by the fact that shrinkage is rarely uniform in all directions.
Shrinkage Factor
The specific processing environment like the melt temperature, the pack pressure, the hold time and the cooling time influences how much the part actually shrinks. A moulder can fine tune the dimensions by adjusting these settings, but only within a narrow range. If the tool steel offset was calculated incorrectly, the process window will be too small to produce consistent parts.
Modification Step
Adjusting the steel after the initial sampling is often necessary to hit tight tolerances. This might involve removing more metal to increase a dimension or adding a coating to reduce one. Accurate initial offsets reduce the number of these expensive and time consuming tool modifications.