Meaning
Intentional deformation of a small area on a mold surface creates a precise metal-to-metal seal. During shut-off coining, the pressure from the mold closing force is concentrated on a narrow land to prevent plastic from flowing into unwanted areas. This technique is used to manage the seal around holes, slots or complex internal features.
It stops functioning when the coining land becomes flattened or crushed beyond its design height.
Sealing Mechanism
Compression of the steel at the interface creates a barrier that even low-viscosity resins cannot penetrate. Using shut-off coining allows for the creation of clean edges on features that are formed by the bypass of two steel surfaces. This method is common in the production of electronic connectors where flash could cause short circuits.
It requires precise calculation of the closing force to avoid damaging the tool. The high pressure at the point of contact creates a physical block against the melt.
Tool Maintenance
Monitoring the height of the coined land is necessary to ensure the continued quality of the molded parts. If the shut-off coining wears down, the molder will observe an increase in flash at the bypass points. Re-coining the surface can sometimes restore the seal without the need for extensive welding or machining.
Proper alignment of the mold halves is essential to prevent uneven wear on these critical surfaces. Regular inspection identifies the point where the seal begins to degrade.
Part Precision
Elimination of secondary trimming operations is the main benefit of a well-executed shut-off. Because shut-off coining creates such a tight seal, the molded features require no additional finishing. This reduces the overall cost per part and improves the aesthetic quality of the product.
Consistent shut-off performance is a hallmark of a high-quality injection mold. The accuracy of the hole geometry is directly linked to the state of the coining land.