Meaning
Undesirable physical condition occurring when air or volatile gases become caught within the melt stream or between the polymer and the tool surface. Instances of gas entrapment injection molding typically manifest as voids or surface burns in the finished component. This occurs when the injection speed exceeds the ability of the venting system to exhaust the cavity.
Cavity Venting
Designing effective channels for air to escape at the end of the flow path is the primary method for preventing this issue. If the vents are too shallow, the air compresses and heats up until it discolors the resin. Deepening the vents improves airflow but risks creating flash if the depth exceeds the viscosity dependent seal limit.
Part Integrity
Internal voids created by trapped gas weaken the structural performance of the part by reducing the effective cross sectional area. These pockets of air also cause unpredictable variations in weight and dimensional stability. Identifying these defects often requires ultrasonic testing or destructive analysis of the batch.
Process Adjustment
Reducing the injection velocity during the final stage of the filling phase allows more time for gas to exit the tool. Lowering the melt temperature also helps by reducing the volume of volatiles generated by polymer degradation. Consistent monitoring of the screw recovery time ensures that the resin remains stable within the barrel.
These changes must balance the need for short cycle times against the requirement for a defect free surface.