Meaning
Plastic injection moulding machines transition from velocity control to pressure control at a specific screw position or cavity pressure threshold to complete the filling of the mould. Dynamic v/p switchover regulates the exact point of this transition based on real-time feedback from internal sensors rather than relying on a fixed mechanical stroke position. This method prevents flash or short shots by reacting to variations in resin viscosity and temperature.
Precise timing of the pressure changeover avoids pack-out, ensures dimensional accuracy, and maintains consistent density across each moulded part.
Hydraulic Response
The control loop relies on high-speed pressure transducers mounted near the gate or inside the cavity to detect when the material front provides sufficient resistance. Modern controllers scan these sensor signals at intervals measured in microseconds to identify the moment the flow front hits the target resistance. Once the threshold is reached, the machine shifts from a volumetric flow rate to a sustained hold pressure.
Slow reaction times in the hydraulic circuit cause the pressure to spike, which risks damage to the tool and uneven stress profiles in the polymer chain.
Material Variation
Virgin resins exhibit predictable flow patterns, but the addition of regrind alters the viscosity and melt flow rate of the compound. Changes in the bulk density of the pellet stock force the machine to adjust its switchover point to compensate for the varying mass of material moved by the screw. A static position setting leads to significant part weight fluctuations when the raw material properties shift between batches.
Sensors that monitor pressure negate the need for manual recalibration during long production runs because the system adjusts to the actual resistance encountered within the mould.
Economic Consequence
Scrap rates drop when the process accounts for environmental variables that shift the injection speed and pressure balance. Reduced cycle times and consistent part quality decrease the unit cost for high-volume manufacturing. Overpacking the cavity requires higher clamp forces and results in increased tool wear, which adds maintenance expenses that erode the margin on complex components.
High-precision switchover logic secures the integrity of the part geometry without requiring frequent operator intervention to adjust the process settings.