Meaning
Mathematical descriptions of isothermal phase change track the time-dependent volumetric transformation of molten polymer into structured solid crystalline domains. Primary crystallisation rates obey avrami kinetics, which relate transformed volume fraction to elapsed holding time through an exponent reflecting nucleation geometry and growth dimensionality. The model ceases to describe behavior once adjacent crystal boundaries impinge heavily, transitioning into secondary crystallisation governed by slow lamellar thickening.
Laboratory differential scanning calorimetry measurements provide raw baseline curves, yet real injection mould cavities experience non-isothermal cooling gradients that depart from classical avrami kinetics.
Nucleation Index
Empirical transformation exponents derived from logarithmic plots quantify whether crystal growth proceeds as planar lamellar discs or three-dimensional spheres. Heterogeneous nucleation active in commercial grades yields lower exponents under rapid cooling. When moulders deploy avrami kinetics to anticipate solid layer formation, discrepancies appear if melt shear has already aligned molecular chains prior to thermal arrest.
Cycle Optimization
Cycle time estimation relies upon understanding the precise moment parts reach sufficient crystalline integrity to withstand ejection force. Through the application of avrami kinetics, tool designers correlate cooling channel efficiency with the rate of solid-layer development. Premature ejection before primary crystallisation finishes causes ejector pin push-through and severe warpage.
Processing engineers alter mould temperature setpoints to shift the kinetic curve, trading shorter cooling cycles against dimensional uniformity. Regrind additions alter crystallisation speed by supplying pre-existing thermal debris that initiates early growth.
Dimensional Precision
Shrinkage predictions fail when process simulation tools overlook the deceleration of volume change during the tail of crystallization. Calculations built upon avrami kinetics reveal that rapid solidification freezes unoriented configurations into the part skin while cores undergo extensive transformation. This density variation across wall sections drives differential volume loss.
Mould cavity dimensions must accommodate both the rapid primary transformation and the subsequent volume reduction that continues after demoulding.