Meaning
Non-propagating electromagnetic wave state that undergoes exponential decay with distance from a boundary provides localized dielectric heating or sensing of polymer melts. In high-frequency curing of thermosetting composites, the evanescent mode generates concentrated electric fields close to the sensor surface to monitor the cross-linking reaction without deep penetration. This localized field is useful for analyzing thin film boundaries and polymer coatings.
If the field decays too quickly, the curing state of the bulk polymer cannot be detected, leading to under-cured cores. The sensor must be calibrated to match the specific profile of the virgin resin.
Field Attenuation
Rate of spatial decay of the non-propagating wave depends heavily on the dielectric properties of the adjacent polymer layer. Utilizing the evanescent mode allows highly localized dielectric analysis because the energy does not travel through the entire tool steel cavity. This extreme localization prevents interference from external electrical noise or mould movements.
Reliable measurements require a very flat polymer-to-sensor contact.
Resin Curing
Thermoset polymer cross-linking changes the complex permittivity of the material, affecting how the non-propagating wave interacts with the polymer matrix. As curing progresses, the evanescent mode sensitivity shifts, providing a real-time trace of the glass transition temperature and gel point. This tracking enables the controller to determine the exact moment to demold the cured part.
The process reduces cycle times while preventing under-cured defect scraps.
Tooling Design
Integration of dielectric sensors into the mould block requires careful boundary dimensions. To maintain an evanescent mode, waveguide dimensions must remain below the cutoff frequency of the wavelength. This geometric constraint restricts the tool steel geometry.
Toolmakers must calibrate these boundaries.