Meaning
Transducer technology placed inside the mould cavity measures the actual force exerted by the polymer melt during the injection and packing phases. Integrated sensing pins or diaphragms within the direct pressure sensor convert physical force into an electrical signal for real-time monitoring. This hardware provides a more accurate reading of the conditions inside the part than machine-mounted hydraulic sensors.
Signal Integrity
Precise data transmission relies on the placement of the sensor away from sources of electrical noise. Shielded cables prevent interference from the heater bands of the injection moulding machine. The direct pressure sensor must maintain a clean signal to detect subtle changes in melt viscosity or gate freeze-off timing.
Cavity Placement
Optimal location for the device is usually near the gate or at the end of the fill to monitor the pressure drop. High pressure at the gate ensures the cavity is filled while pressure at the end of fill confirms the part is fully packed. Choosing the correct position allows for the detection of short shots or over-packing.
Flash occurs when the pressure exceeds the clamping force of the machine.
Trace Analysis
Process control software uses the data to create a pressure curve for every cycle. Variations between cycles indicate shifts in material lot, regrind ratios, ambient temperature or moisture levels. The direct pressure sensor allows the controller to switch from injection to holding pressure based on the internal state of the mould rather than the position of the screw.
Automated rejection systems use these curves to remove parts that fall outside of the established quality window. Monitoring the peak pressure helps maintain dimensional stability across a long production run.