Meaning
Mechanical resistance encountered when stripping a moulded plastic part from a core or male mould feature represents a critical parameter in injection moulding cycle efficiency. Solidifying polymer shrinks onto the steel core during the cooling phase, which generates core ejection drag during the demoulding stroke. Excessive force during this stage can deform the part or cause ejector pins to punch through the plastic wall.
Controlling the mould temperature and applying appropriate draft angles minimise this drag.
Friction Mechanism
Frictional forces during demoulding depend heavily on the surface finish of the steel core and the coefficient of friction of the specific polymer. Semi-crystalline resins like polypropylene shrink more than amorphous resins, which increases the clamping force on the core and intensifies core ejection drag. A polished core sometimes increases adhesion rather than reducing it, so a specific micro-texture is often preferred to break the vacuum.
This mechanical interaction determines the minimum ejector pin area required to prevent part puncture. In addition, the use of internal release agents blended into the resin can decrease the interfacial shear strength between the polymer skin and the steel.
Process Influence
Cooling time and holding pressure directly determine the magnitude of the ejection force. Over-packing the cavity increases the density of the part and prevents normal shrinkage, which reduces core ejection drag but can cause flashing or other defects. Insufficient cooling leaves the polymer too soft to withstand the ejection stroke.
Consequently, the part can warp or twist as the ejector system tries to push it off the core.
Defect Correlation
Surface blemishes and stress marks often appear on the moulded part when the demoulding force is too high. In severe cases, the ejector pins leave permanent white stress marks or push directly through the thin plastic wall. Adding an internal draft angle of at least one degree helps to relieve core ejection drag immediately after the ejector stroke begins.
This geometrical relief is standard in industrial mould design to ensure clean part release.