Meaning
Brittle surface regions formed during electrical discharge machining consist of a hard recast zone that has been rapidly quenched by the dielectric fluid. If a white layer remains on the moulding surface of a tool, the resulting tension can lead to microcracking and eventual spalling of the cavity steel. The name comes from the appearance of the affected metal under a microscope after etching, where it appears as a bright, un-etched band.
This layer is significantly harder and more brittle than the base metal.
Surface Hardness
Extreme quenching rates during the EDM process create a martensitic structure that is often too hard for practical use. While this might seem beneficial for wear resistance, the white layer is prone to chipping under the cyclic loads of injection moulding. The thickness of the layer depends on the energy of the sparks used during the machining operation.
Crack Risk
Tensile stresses trapped within the recast zone can cause cracks to propagate into the substrate of the tool steel. Even if the white layer is thin, these microcracks act as sites for fatigue failure during production. Identifying and removing this compromised material is a standard requirement for high-performance tooling.
Removal Procedure
Mechanical polishing or chemical etching is used to strip away the brittle material and reveal the sound steel beneath. A final EDM pass using low energy can minimize the thickness of the white layer, but mechanical removal is preferred for critical surfaces. Ensuring the complete removal of this zone is the last step in preparing a cavity for textured or high-gloss finishes.