Meaning
Maximum force exerted by the hydraulic fluid within a machine circuit occurs during the transition from the injection phase to the holding phase. Monitoring peak hydraulic pressure indicates the resistance the molten polymer encounters as it fills the mould cavity. This variable is a consequence of the melt viscosity and the geometry of the runner system.
Observing this value ensures that the injection moulding machine operates within its mechanical design limits.
Filling Resistance
Viscous resins like polycarbonate require higher forces to push the material through thin wall sections. Peak hydraulic pressure rises when the melt temperature is too low or when the injection speed is set too high. This increase in pressure can cause the machine to hit its safety ceiling, resulting in a short shot.
Adjusting the barrel temperature or the gate size helps to manage this pressure demand.
Clamping Force
High internal pressures must be countered by the mechanical force holding the mould halves together. Peak hydraulic pressure correlates with the cavity pressure that tends to push the tool open. Flash develops along the parting line if the hydraulic force exceeds the clamp capacity.
Component Longevity
Frequent spikes in the hydraulic lines accelerate the wear on valves and seals. Peak hydraulic pressure should ideally stay below eighty percent of the maximum rated capacity of the pump. Operating near the limit increases the risk of hydraulic hose failure or internal oil leaks.
A well optimized process balances the speed of production with the mechanical preservation of the moulding equipment.