Meaning
Excessive polymeric material protruding beyond the design boundary of a moulded part occurs when the gate seal or shut-off mechanism fails to hold a clean shear plane. This cosmetic and dimensional issue, known as gate vestige flash, typically develops during the ejection or de-gating phase of the injection moulding cycle. It signals that molten plastic has squeezed into worn clearance spaces or failed to freeze off completely before part separation.
Correcting this requires careful attention to tool maintenance and cycle timing.
Defect Origin
Molten resin under high cavity pressure travels into any available micro-gap when the steel faces of the gate insert do not meet flush. High shear rates during fill degrade the polymer chains locally, decreasing viscosity and making the melt more prone to escape. When gate vestige flash appears, it alters the assembly clearances of the final product.
Moulders must measure the height of the gate protrusion to confirm it sits within acceptable drawing limits. If the defect is left unchecked, it can cause mating parts to fail during automated assembly, which leads to high reject rates and line stoppage.
Tooling Wear
Repeated mechanical abrasion from abrasive glass-filled resins gradually erodes the sharp edges of the gate land. This erosion increases the gap between the valve pin and the gate orifice, preventing a clean mechanical seal. Thermal expansion differences between the hot runner tip and the cold mould plates can also distort the gate geometry.
When such tool degradation occurs, the gate vestige flash increases in height and thickness.
Process Remediation
Cooling time extensions allow the plastic at the gate to solidify fully before the tool opens. Adjusting the decompression or suck-back stroke of the screw relieves pressure on the hot runner manifold before mould opening, preventing drool. This adjustment limits the material volume available to form gate vestige flash.
It ensures that the sheared edge remains clean and flush with the part surface.