Meaning
Electrical charge storage in the feedback loop of an operational amplifier determines the conversion factor of a charge amplifier used in cavity pressure monitoring. By selecting a specific feedback capacitance, the moulder sets the measurement range of the sensor system to match the expected pressure of the injection cycle. This design choice scales the picocoulomb output of the piezoelectric crystal into a readable voltage signal.
The performance is bounded by the leakage current of the capacitor and the resolution of the analog-to-digital converter.
Sensor Scaling
Low pressure ranges require a small capacitor to generate a clear, strong voltage output. When the feedback capacitance is too small, however, the amplifier may saturate during high-pressure injection phases. This saturation truncates the pressure curve and hides the peak packing pressure from the operator.
Proper selection depends on the sensor size and the mould geometry.
Process Stability
Quality control drops when signal saturation goes unnoticed. If the amplifier output flatlines, the controller cannot detect pressure spikes that cause flashing or mold damage. Incomplete data prevents the automatic rejection of defective parts.
System Configuration
Changing the gain settings on modern charge amplifiers automatically switches between internal reference capacitors. This adjustment allows the same sensor to monitor thin-walled parts requiring high pressures or thick parts requiring lower pressures. Routine electrical tests verify that the capacitors maintain their nominal values over long-term operation.