Meaning
Electronic signaling from sensors located inside a mould tool defines the transition from filling to packing. Cavity pressure feedback provides the machine controller with actual melt conditions, bypassing the hydraulic pressure at the ram. Sensors typically sit behind a pin or directly in the melt stream.
Real-time data allow for automatic adjustment of the switchover point to compensate for viscosity shifts.
Automated Transfer
Closing the loop between the tool and the press reduces the scrap produced by fluctuating material properties. When cavity pressure feedback dictates the transition to the holding phase, the system accounts for changes in regrind percentage or ambient temperature. The machine adjusts the injection profile in real time to ensure every part reaches the same density and dimensions.
It effectively removes the human element from the tuning process by responding to internal melt behavior.
Yield Improvement
Short shots and flash are minimized when the pack phase begins at a precise internal pressure. Consistent cavity pressure feedback prevents the overpacking of cavities near the gate while ensuring those further away receive sufficient melt. This control is necessary when moulding high precision parts from semi crystalline resins with high shrink rates.
Sensor Maintenance
Regular cleaning of the sensor pocket is required to maintain the integrity of the measurement. If debris enters the pocket, the cavity pressure feedback signal drifts. This causes weight variation.