Meaning
Injection molding machine control actions transition the drive mechanism from speed-controlled cavity filling to pressure-controlled packing and holding. Establishing the correct velocity switchover point prevents the mold from being over-pressurized while ensuring the cavity is completely filled. This transition is typically triggered by screw position, cavity pressure, or elapsed injection time.
Transition Mechanics
The injection screw moves forward at a specified velocity to inject the polymer melt into the mold cavity. At the designated switchover point, the controller switches from velocity control to holding pressure to pack out the part. If this transition occurs too early, the part will suffer from short shots and sink marks.
Defect Prevention
Delaying this control transition too long results in over-packing the cavity, which causes severe flashing, high molded-in stresses, and difficulty in part ejection during the mold-open phase. The expensive mold tool itself can be damaged by the high hydraulic pressures generated if the injection screw continues at high velocity after the cavity has already filled. Locating the optimal switchover point through viscosity curves is essential for maximizing mold life and maintaining part weight consistency.
Process Monitoring
Cavity pressure sensors provide the most reliable method for triggering this control action during high-tolerance molding runs. By monitoring the pressure rise as the melt reaches the sensor, the controller executes the transition independently of material viscosity shifts. This advanced monitoring reduces part weight variation and stabilizes the molding process.