Meaning
Injection moulding machines trigger the transition from velocity-controlled filling to pressure-controlled packing once a specific cavity fill percentage is reached. This switchover point manages the shift from high-speed resin flow to high-pressure compression inside the mould. It governs the volumetric shrinkage occurring as the molten polymer cools within the tool.
Accurate calibration prevents flash at the parting line or short shots throughout the part geometry.
Process Dynamics
Hydraulic or electric systems sense the internal melt pressure or the screw position to command this event. A delay in the signal causes over-packing, which places excessive stress on the tie bars and damages the tool face. Conversely, an early trigger leads to incomplete parts as the material fails to reach the extremities of the mould.
Moulders adjust this variable based on the viscosity of the specific resin grade. High flow materials require precise timing to avoid excessive injection rates during the final stage of filling.
Material Economics
Virgin resins possess consistent rheological properties that allow for repeatable machine settings over long production cycles. Regrind introduces variation in molecular weight and impurity levels, which shifts the required setting for optimal part weight. Processors compensate for these deviations by mapping the pressure drop across the nozzle and runner system.
A stable setting reduces the amount of scrap generated during the start of a production run. Stable parameters ensure the part meets the dimensional requirements defined by the original technical drawing.
Tooling Calibration
Mechanical sensors monitor the physical limit of the screw travel to ensure the cavity volume receives the intended mass of polymer. Tooling engineers specify the volume required based on the final part density and the contraction rate of the cooling material. If the mould cavity size fluctuates due to thermal expansion, the required mass for the fill stage changes accordingly.
Adjustments to the packing time maintain the correct dimensions of the final component. Consistent control of this phase prevents internal void formation in thick sections of the part.