Meaning
Continuous replenishment of the liquid-gas interface of a polymer melt during devolatilization defines the mass transfer mechanism of volatile removal. Surface renewal is achieved through intense mixing and shearing within the extruder, which forces entrapped gases and volatile monomers to the surface where they can escape into the vacuum system. This mechanism is crucial for stripping residual solvents and moisture from highly viscous polymer melts, which prevents the formation of bubbles and surface defects in the finished part.
Extruder Design
Co-rotating twin-screw extruders use specialized kneading blocks and multi-flighted screw elements to split and recombine the melt. These elements constantly create new surface area by exposing inner layers of the melt to the vacuum zone. Without this active mixing, the high viscosity of the polymer limits volatile diffusion, resulting in inefficient degassing.
Mass Transfer
The rate of devolatilization depends on the frequency with which the melt surface is replaced. Frequent surface replacement reduces the concentration gradient at the interface, maintaining a high driving force for evaporation. High screw speeds increase this replacement rate but must be monitored to avoid excessive melt temperatures.
Moulding Defect
Inadequate renewal leaves residual volatiles in the polymer. These volatiles expand during moulding, causing surface silvering or internal voids in the part.