Meaning
Polymer resin preparation requires a specific limit on residual water content to prevent hydrolytic degradation during melt processing. This dry state, known as the baseline moisture threshold, represents the maximum concentration of water a material can hold before polymer chains begin to cleave in the barrel. For hygroscopic resins like polyamide or polycarbonate, exceeding this limit results in lost tensile strength and cosmetic splay.
Processors must verify this value using loss-on-drying instruments or Karl Fischer titration before commencing a run.
Hydrolytic Reaction
Thermal degradation occurs rapidly when moisture-laden polymer granules encounter the high temperatures of the injection moulding barrel. Under these conditions, the baseline moisture threshold defines the safety boundary where water molecules cannot drive extensive chain-scission reactions. When water levels exceed this value, the resin viscosity drops sharply as molecular chains break down.
This degradation reduces the mechanical properties of the finished part below its specified datasheet values.
Processing Outcome
Cosmetic and structural defects emerge directly from the gaseous expansion of trapped water vapor as the melt moves through the nozzle into the mould. When the resin is processed above its baseline moisture threshold, the vaporized water creates silver-like streaks known as splay on the part surface. These internal voids act as stress concentrators that compromise the impact strength of the moulded article.
Moulders must reject such parts because the damage occurs at the molecular level during the high-heat phase. This loss of structural integrity cannot be recovered through post-processing or annealing, making online moisture testing a critical step in the quality control protocol.
Drying Management
Ensuring that the resin is properly prepared involves drying systems that lower the moisture content to a stable level before the material enters the hopper. Monitored desiccant dryers reduce the dew point of the air to maintain the baseline moisture threshold over multi-hour production runs. If the drying temperature is too low, the water remains bound inside the pellets, while excessive temperatures can oxidize the resin.
Controlling these parameters prevents hydrolytic damage and maintains consistent melt behavior.