Meaning
Injection moulding parameters identify the precise transition point from velocity controlled filling to pressure controlled packing in the cycle. Switchover timing defines the exact interval when the machine stops moving the screw at a set rate and begins exerting holding force to compensate for thermal contraction. This transition prevents short shots or excess flash by shifting control before the cavity reaches total volume.
The adjustment occurs during the secondary phase of the injection sequence to ensure dimensional stability.
Phase Trigger
Control logic within the controller manages this transition based on position sensors or pressure transducers. Process technicians adjust the switchover timing to account for resin viscosity variations when switching between virgin material and regrind supplies. A deviation in this setting causes immediate internal stress variations within the part.
Consistent timing maintains the structural integrity of the moulded article across large production volumes.
Cost Impact
Excessive delay in the switchover timing causes overpacking of the mould cavity which increases internal part stress and creates sticking issues at the ejector pins. Premature triggering prevents the melt from reaching the extremities of the mould geometry and produces incomplete features. The financial consequence of improper calibration shows in high scrap rates or secondary operations needed to remove flash.
Consistent control over this timing reduces wear on the hydraulic pump and clamp assemblies by minimizing peak pressure spikes.
Material Constraint
Semi-crystalline polymers require sharper control of this setting compared to amorphous resins due to the high shrinkage rates associated with phase changes during cooling. Datasheet values provide a starting point for injection velocity yet the actual setting relies on the specific resistance of the gate size and runner layout. Moulders often hold this value within narrow tolerances across a production run to ensure that every shot maintains identical weight and density.
Precision at this stage governs the performance of the part in its final application.