Meaning
Machined pathways in an injection mould that guide molten polymer from the sprue to the gates of the cavities define the melt delivery system. These runner channels must be designed to minimize pressure drop and temperature loss during the injection cycle. Proper design ensures that each cavity fills at the same rate and pressure, which reduces part-to-part variation.
Poorly designed pathways can cause premature freezing, short shots, or excessive moulding flash.
Flow Resistance
Cross-sectional geometry dictates how much pressure is lost as the melt travels through the system. Circular runner channels offer the lowest flow resistance, which minimizes heat loss. Trapezoidal configurations are sometimes chosen for ease of machining, but they increase resistance and require higher pressures.
Sizing Optimization
Balancing the diameter is necessary to avoid both high pressure loss and long cooling times. If the runner channels are too small, the polymer will freeze before the cavity is packed, causing sink marks and dimensional instability. Conversely, oversized pathways extend the cycle time since the runner is the thickest part and takes the longest to solidify.
Engineers use flow simulation software to find the minimum diameter that satisfies pressure and packing requirements.
Scrap Allocation
Frozen material left in these delivery paths represents process waste that must be managed. In conventional cold runner systems, the runner channels generate scrap that must be regrown or reground and blended with virgin resin. The economic impact of this scrap depends on the regrind ratio and the cost of the raw polymer.
Hot runner systems eliminate this scrap entirely but increase tooling costs.