Meaning
Atmospheric analysis procedures quantify the emission of volatile organic compounds from interior components in road vehicles. The protocol known as din iso 12219-2 defines the use of a ten litre micro scale environmental chamber to capture gaseous substances released under controlled thermal and airflow conditions. This measurement technique supports the assessment of material influence on cabin air quality by simulating the primary degradation or desorption phase of plastics and foams.
Test Configuration
Operators place samples inside a small stainless steel vessel to isolate the specific emission profile of a single material layer. A controlled stream of purified air moves through the chamber at a constant rate to ensure the representative dilution of desorbed compounds. Dynamic equilibrium maintains the temperature at a level consistent with interior cabin heating cycles to force the release of solvents or additives trapped within the polymer matrix.
Emission Variable
Results provide a concentration value of organic substances per unit of time or surface area for internal automotive surfaces. Low concentrations suggest high thermal stability of the raw resin and a clean secondary processing stage that avoids the retention of moulding lubricants or cleaning agents. Excessive emission levels often arise from insufficient degassing of the polymer melt or the presence of volatile monomers resulting from incomplete conversion during production.
Material Specification
Standards differentiate between virgin pellets and finished moulded parts because the injection process itself introduces chemical shifts through mechanical shear and thermal residence. Datasheets typically report basic physical properties while this testing method establishes the actual chemical release rate from the final geometry under real environmental stress. A moulder ensures compliance by restricting the use of low grade regrind that increases the probability of higher emission values across a production run.