Meaning
Chemical concentration measurements define the quantity of organic acid end groups present along a polymer chain per unit mass of resin. In polyesters like polyethylene terephthalate and polyamides like nylon 66, carboxyl content quantifies the balance between reactive terminations and unreactive chain ends. This parameter governs melt stability during high-temperature injection moulding and sets the hydrolytic sensitivity of finished parts exposed to humid environments.
The metric applies strictly to condensation polymers containing free carboxylic acid terminations and excludes non-functional olefinic polymers.
Acid Titration
Quantitative determination relies on dissolving the resin in a heated polar solvent like benzyl alcohol followed by potentiometric titration using standardized ethanolic potassium hydroxide. Measuring carboxyl content through this volumetric approach isolates acidic end groups without interference from neutral backbone ester linkages. Titration endpoints indicate the milliequivalents of acid per kilogram of polymer, which directly correlates with molecular weight when monomer stoichiometry is fixed.
Higher values indicate shorter polymer chains or extensive thermal degradation during compounding.
Viscosity Drift
Chain scission under excess thermal exposure or unremoved moisture increases acid group density rapidly during melt processing. When carboxyl content increases in the extruder barrel, low molecular weight fragments reduce melt viscosity and lower the mechanical strength of the moulded component. Uncontrolled end-group growth promotes auto-catalytic hydrolysis in service, causing premature cracking in automotive fluid lines.
Virgin resin specifications enforce upper limits on carboxylic group concentrations to prevent melt instability during re-processing of sprues and runners.
Moulding Response
Holding strict limits on acid group concentration ensures consistent barrel residence times and uniform part density. High carboxyl content in raw pellets causes variable cavity filling and flash formation in heavy-wall mouldings. Regrind additions increase acid end groups due to prior heat histories, requiring adjustments to drying cycles to halt further degradation.