Meaning
Short-chain polymer molecules in a resin formulation alter the rheological properties and the mechanical performance of the finished parts. The presence of low molecular weight polyolefin can act as an internal lubricant, reducing the melt viscosity and improving the processability of the resin during moulding. However, these shorter chains also migrate easily to the surface of the part, where they can cause surface defects and affect adhesion.
Balancing the concentration of this fraction is necessary to optimize processability without compromising the mechanical strength of the product.
Rheological Influence
High-shear processing of thermoplastics is made easier when the melt viscosity is lowered by the addition of low-viscosity fractions. Incorporating low molecular weight polyolefin into the compound reduces the injection pressure and torque required to fill complex moulds. This lubrication effect helps prevent high-stress areas in the moulded part, reducing the risk of post-moulding warpage.
On the other hand, an excess of these short chains reduces the tensile strength and impact resistance of the final product. Moulders must monitor viscosity changes to prevent flash and short shots.
Surface Quality
Migration of mobile polymer fractions to the outer surface of a moulded component can lead to aesthetic and functional issues. When low molecular weight polyolefin accumulates on the surface, it forms a wax-like layer that prevents proper bonding of paints, adhesives, and coatings. Moulders must control processing temperatures and cooling rates to minimize this migration and ensure a uniform surface finish.
Processing Economics
Recycled resin streams often contain a higher concentration of degraded, shorter chains due to the thermal stress of previous processing cycles. Measuring the amount of low molecular weight polyolefin in regrind batches allows moulders to adjust their processing parameters to maintain part consistency. While regrind is a cost-effective alternative to virgin resin, too much degraded material leads to flash, gas burning, and brittle part failure.
Managing this low molecular weight fraction optimizes regrind usage and keeps production costs low.